|
Crop History
Canola Production and Processing
Trade
Consumption
Global canola production has grown rapidly over the
past 40 years, rising from the sixth largest oil crop
to the second largest. Canola production was 10-15 percent
of world oil crop production between marketing years
1999/2000 and 2008/09. Canola oil, obtained from crushing
canola seed, was the third most produced vegetable oil
globally in 2008/09. Between 1999/2000-2008/09, canola
oil was 13-16 percent of world vegetable oil production.
Canola meal is the second largest feed meal after soybean
meal.
In 2008/09 (May/June), the farmgate value of U.S. canola
production was $270 million. The U.S. share of world
production remains small, but is of growing importance
to regional economies in the Northern Plains. Almost
all canola is crushed into oil and meal. Trends in the
much larger Canadian canola industry have a significant
impact on production and processing of canola in the
United States.
The dramatic success of the canola brand in North America
has caused the word "canola" to become synonymous
with edible rapeseed in much the same way the word "Xerox" is
understood to be a photocopy. Today, nearly all production
in North America uses edible rapeseed varieties, and
discussions of production typically refer only to canola.
Other areas of the world where canola varieties are less
widely used continue to use the term "rapeseed" for
both edible and inedible varieties. This web page uses
terminology familiar in North America.
Crop History
Since World War II, global production of rapeseed and
canola has grown dramatically. During WWII, inedible
rapeseed oil was used as a high-temperature lubricant
on steam ships, but with the switch to diesel engines
in the following decade, industrial demand declined.
Initially, consumer demand for rapeseed oil was negligible
because it naturally contains high amounts of erucic
acid. Erucic acid was enough of a concern that in 1956,
the U.S. Food and Drug Administration (FDA) banned rapeseed
oil for human consumption. In addition, demand for rapeseed
meal was low due to high levels of glucosinolates, a
compound that at high doses depresses animal growth rates.
By the early 1970s, plant breeders
developed low-erucic acid rapeseed (LEAR) varieties that
also had low glucosinolate content. In 1978, the Western
Canadian Oilseed Crushers Association registered these
varieties with the name "canola" for
marketing reasons. Over the next 10 years, European seed producers also developed
LEAR varieties, which they dubbed "double-zero" or "canola-equivalent."
Due to the higher palatability of LEAR varieties, FDA granted
the oil produced from LEAR varieties Generally Recognized
as Safe (GRAS) status on January 1, 1985. With its low
level of saturated fat, LEAR oil appealed to health-conscious
consumers and production increased steadily.
Government support programs for minor oil crops began
with the Food, Agriculture, Conservation, and Trade Act
of 1990 and have decreased producer risk and increased
profit for these crops. Canola producers became eligible
for Marketing
Assistance Loans/Loan Deficiency Payments in 1991,
Oilseed Program Payments (a supplemental program authorized
for 1999-2001 soybean and minor oilseed crops; see the
2001
Oil Crop Yearbook for
more information) in 1999, Direct
Payments in 2002, Average
Crop Revenue Election Payments in 2009, and Counter-Cyclical
Payments in 2010.
d
png | jpg
Canola Production
and Processing
Global canola production is concentrated away from the
equator in areas with dry weather and shorter growing
seasons. In Europe, Ukraine, Russia, and parts of China,
winter canola is planted between September and November
before the winter begins. These areas freeze in the winter
but temperatures do not get cold enough to kill overwintering
plants. When spring arrives, canola emerges more quickly
than it would if it were planted in the spring, producing
a 20-30 percent larger yield. Spring canola varieties
are primarily planted in parts of China, India, Canada,
and the United States. Spring canola varieties mature
as early as 85 days after planting, depending on the variety
and weather conditions.

U.S. Production
U.S. canola production is concentrated in the Northern
Plains where a dryer, shorter growing season makes corn
and soybean production less attractive (see 2007 Census
of Agriculture maps for Canola
Harvested Acres). In 2009, 90 percent of production
was in North Dakota, with smaller amounts in Minnesota,
Montana, and South Dakota. Roughly 30,000 acres of
canola grown for planting seed are scattered throughout
Colorado, Montana, and Idaho to supply U.S. and Canadian
farmers.
Producers apply nitrogen, phosphorus, sulfur, and potassium
in the spring before or at planting. Sulfur requirements
are higher than for other crops. New crop varieties that
are resistant to herbicides have helped to decrease the
risk and effort associated with canola production.
One of the most significant limits on canola production
remains the small timeframe producers have to harvest
the crop. To reduce concerns over immature seed problems
(green seed) and seed shatter losses, canola is harvested
at a specific point in crop development. Because canola
ripens very quickly, there can be considerable time
pressure on producers even if they stagger planting
in their field with canola varieties that mature at
different times. Producers generally swath canola in
much the same way as spring wheat. They cut the ripening
plants and leave them to dry in the field for 10-14
days. After the moisture content of the seed drops
to a safe storage level, producers combine and collect
the seed for storage or sale.
In the Northern Plains, canola is typically planted in
rotation with small grains including wheat, barley, oats,
and flax, although rotations vary considerably in this
region and include many other crops. Ideally, canola is
included in a rotation every 3-4 years to minimize the
spread of pests and diseases. Other crops highly susceptible
to Sclerotinia (white mold), especially sunflowers
and dry beans, should not be planted in rotation with canola.
Soybeans, lentils, and field peas are slightly susceptible
to Sclerotinia but are still commonly grown in
rotation with canola.
2007 Census of Agriculture
The 2007 Census of Agriculture reported canola production
in 2007 steady with production in 2002 (see Canola
production in the United States by farm size ).
In 2007, 3,123 farms harvested canola, compared with 3,831
in 2002 and 2,892 in 1997. As the number of farms declined
between 2002 and 2007, the amount of harvested acreage
remained about the same. The number of large farms over
1,000 acres increased 23 percent while the number of farms
under 100 acres declined 33 percent. Only 13,535 acres
were irrigated in 2007.
Processing
Canola seed is typically not sold to consumers but is
crushed at processing facilities into oil and meal. The
small, round seed contains 38 to 45 percent oil. Crushing
plants are able to remove most of the oil and nearly all
of the remaining material is a suitable meal for livestock
feed. Canola oil is the most valuable crush component
and provides the majority of crushing plant revenue. Canola
seed is first pressed to extract the bulk of the oil and,
afterwards, most crushing facilities add a chemical solvent
to remove the remaining oil. The supply of canola meal
and oil are linked through the crushing process even though
demand for these products is independent.
Major crushing plants in North America are located in
central North Dakota and Prairie Provinces in Canada.
One plant in North Dakota can process 1,000 tons per
day or roughly two-thirds of the U.S. crop. The location
of crushing plants facilitates trade between the United
States and Canada because it is often cheaper for firms
to import seed from across the border than to
purchase from a more distant domestic location.
Trade
As canola production has expanded over the past 20 years,
global trade in canola seed and products has also increased.
However, trade continues to be a smaller share of production
compared with other major oilseeds. Trade in canola
meal is limited due to the abundance of higher quality
soybean meal and the high cost of transportation relative
to the value of canola meal. Japan, Mexico, China, and
the European Union (EU) are major importers of canola
seed. The United States is the primary importer of canola
oil and meal because of its proximity to Canada and the ease
of cross-border trade.

Canada accounts for more than half of world trade in
canola seed, meal, and oil. Canadian producers continue
to expand canola area and production. Demand prospects
look strong due to growing use of vegetable oils in
China and India and canola-oil-based biodiesel use in
the EU. The Canadian crushing industry is growing fast
to support increased demand for canola oil. In the next
2 years, more than 1.5 million metric tons of canola
crushing capacity is expected to be built in the Canadian
Prairie Provinces. Some of the increased canola oil
may be used to produce biodiesel. As Canada's nearest
neighbor and fellow North American Free Trade Agreement
(NAFTA) member, the United States will likely continue
to purchase the majority of Canadian exports of canola
oil and meal.
In the past few years, biodiesel producers in the EU
have dramatically increased demand for canola oil and
crush capacity has expanded considerably. Though EU canola
production has expanded to support this industry, the
EU has also become a significant importer of canola seed.
Much of these imports arrive from Ukraine, Belarus, and
Russia. These countries have expanded canola area over
the past 5 years and there appears to be plenty of room
for continued expansion if demand remains strong. Ukraine,
in particular, doubled production in 2006, nearly did
so again in 2007, and more than doubled output in 2008
to become the second largest canola exporter in the world.
Consumption
Canola seed
In the United States, canola seed is typically not consumed
directly but instead crushed for oil and meal. A limited
number of Asian countries, including India, consume canola
seed as a source of food.
Canola Oil
Food use: Canola oil is the third largest source
of vegetable oil in the world after soybean oil and
palm oil, and use is continuing to grow. In the
United States, canola oil is used in frying and baking
applications and is an ingredient in salad dressings,
margarine, and a variety of other products. Canola oil
appeals to health-conscious consumers because it has
a low percent of saturated fat and is free of artificial
trans-fats. High-oleic canola varieties have been developed
recently that are used in commercial high-temperature
frying applications to replace partially hydrogenated
oils.
Industrial use: In the early 2000s, canola oil
prices were competitive with soybean oil and biodiesel
producers considered making biodiesel from canola oil.
However, since that time, canola oil prices increased
and in 2008/09 (Oct/Sept) commanded a 23-percent
price premium over soybean oil. Due to increasing and
inelastic canola oil demand for food use, it is unlikely
that biodiesel producers in the United States will use
significant amounts of canola oil. Instead, soybean oil
and tallow are preferred for their lower price and wider
availability.
Unlike the United States, the majority of European cars
and trucks run on diesel. As a result, EU biofuels initiatives
are primarily aimed at the production of biodiesel.
Higher greenhouse gas reductions from biodiesel production
versus ethanol production also favor this approach.
Canola is the primary oil crop grown in the EU and Eastern
Europe and abundant supply makes it the natural feedstock
for biodiesel. EU biodiesel policies, especially cold-weather
fuel standards, also favor the use of canola oil. With
increasing biofuels mandates, industrial use of canola
oil has grown rapidly in the EU, from 1.247 million
metric tons in 2002/03 (July/June) to 5.791 million
in 2008/09. In 2008/09, industrial use of canola oil
in the EU was 69 percent of production, most of which
was used to produce biodiesel.
A small amount of high-erucic acid rapeseed (HEAR) oil
is produced in the United States. HEAR oil is used in
a variety of industrial and consumer products, from lubricants,
hydraulic fluids, and penetrating oils to fuel, soap,
and paints. HEAR oil is biodegradable and is used in applications
requiring high heat stability where the risk of oil leaking
into waterways or ground water is significant. In the
United States, HEAR is grown under contract and is not
introduced to the regular grain handling system.
Canola Meal
Canola meal is the second largest protein meal produced
in the world, although it is dwarfed in size by the
production of soybean meal. In marketing year 2008/09,
global canola meal production was 30.8 million metric
tons, versus 151.6 million for soybean meal. Canola
meal has a lower protein content than soybean meal (34-38
percent versus 44-49 percent) and fewer key amino acids.
Therefore, canola meal is an
economical protein source for animals that do not have
high energy or lysine requirements.
Canola meal is primarily fed to cattle and pigs as part
of a feed ration. The majority of canola meal in the United
States is fed to dairy cows because the high fat content
of the meal enhances milk production. Poultry, aquaculture,
and specialty animals (including racehorses) can also
be fed canola meal as a protein source although limited
crushing locations, high fiber content, and low palatability
limit feeding rates.
For More Information
- USDA, Economic Research Service (ERS)
- Oil Crops Yearbook tables
- Table
24, Canola seed: Supply, disappearance,
and price, U.S.
- Table
25, Canola oil: Supply, disappearance, and
price, U.S.
- Table
26, Canola meal: Supply, disappearance,
and price, U.S.
- USDA, National Agricultural Statistics Service (NASS),
Statistics
by Subject (Click on "Canola" or "Rapeseed")
- National Statistics
- Link to Quick Stats, which contains data on planted
and harvested acreage, yield, production, and value
at the National, State, and county levels
- Links to all recent reports on acreage, prices,
production, stocks, and value
- USDA, Foreign Agricultural Service (FAS)
- USDA, Agricultural Marketing Services (AMS)
|